Skip to Content

Mark a scan as reviewed

When you review a site scan by scan, for example to check a model, mark each scan as reviewed once you have finished with it. Reviewed scan positions turn grey on the site map and the minimap, so everyone can see what is left.

The button shows at every access level, but only Master can use it. Other levels see Not permitted.

Mark a scan reviewed

  1. Enter the scan.
  2. On the bar at the bottom of the scan, beside the Model and Image slider, click the checkbox button. Its tooltip reads Mark this scan reviewed.

The button turns red and its tooltip changes to Reviewed. Click to unmark. The scan position turns grey and shows as Reviewed in the legend.

To remove the mark, click the button again.

See progress

Click Pins on the rail. Above the pin list, a line shows how many scans have been reviewed, for example "12 of 40 scans reviewed".

Clear every reviewed mark

  1. In Pins, beside the reviewed count, click Reset.
  2. In Reset reviewed positions, click Reset all.

This clears the mark from every scan position on the site and cannot be undone.