Log work
Log work records what you did on a job. Ticking The work is finished also finishes the job.
Log work
- Open the job and tap Log work.
- Enter What you did and What you found.
- Enter the Hours.
- Under Parts used, choose a Part, enter How many, and tap Add this part. Repeat for each part. Each part shows how many are on hand.
- Under Photos, tap Add a photo to take or choose photos.
- To finish the job, tick The work is finished. The job's checklist appears. Answer every step.
- Tap Save.
Screenshot to comeThe Log work form in Matrise Field with What you did, Hours, Parts used, Photos and The work is finished.
Check and preventive jobs
These are finished by recording an inspection, so the form shows "This job is finished by recording an inspection." instead of the tick box. See Record an inspection.
If a message appears
- Say what you did.: fill in What you did.
- This task needs at least one photo of the work before it can be finished. Add one under Photos.
- A message that the checklist is not on this phone yet: save without finishing, or open the form again when there is a signal.
- On a site that requires failure codes, finishing corrective work can be refused with "This job needs the problem, cause and remedy, which are added on the portal. Ask your supervisor." The codes are added on the portal. See Record failure codes on a job.